**Pistorius, CTD
***MD4-365 includes bushing from 20mm to 3/8".
****MD5-505 includes bushing from 20mm to 10mm. ♦ denotes 5/8" arbor with ♦ diamond
knockout
*Plates w/copper plugs.
+ For use on a Riesle Up-Cut Saw, For Hurricane Shutters
++ Thin Kerf
Warning:NEVER attempt
to cut ferrous metals (steel, iron, etc.) with these
saw blades. Non-Ferrous blade
is not to be used on multi-purpose cut-off saws or gas
power saws, unless saw has a guard that covers both the
upper half an d the lower half of the blade completely.
The guard must extend to the lowest point of the cutting
teeth on the bottom of the blade. Consult machine owner’s
manual and follow all instructions and safety procedures
- including wearing safety goggles at all times while
working with this blade. NOTE: Due to the rough applications
for which these blades may be used, they are not guaranteed.
Products shown in Bold indicate most popular saw blades.
Thick Walled
Saw Blades The special carbide formulation and
blade geometry makes this blade ideal for cutting aluminum
and non-ferrous metal bars such as copper, brass, bronze and lead.
Also, good for cutting relatively thick-walled extrusions and profiles.
The negative hook angle, triple-chip grind and thick plate
combine to produce a superior finish. Use as coolant or blade
wax and clamp down the work piece when cutting non-ferrous
metals. The blade can be used to cut other “difficult” materials
such as plastic, PVC tubing and fiberglass.
Thin Walled Saw Blades Designed specifically for cutting relatively
thin-walled aluminum and non-ferrous extrusions and frames. Use
a coolant or blade wax and clamp down the work piece when cutting
non-ferrous metals.
